Wholesale V 35 Rj45 Protocol Converter - Unframed E1-FE Converter JHA-CE1F1 – JHA

Unframed E1-FE Converter JHA-CE1F1

Overview

This interface converter provides one unframed 2048K E1 interface and one Ethernet interface to achieve 10/100Base-T Ethernet data transmission on the E1 channel. It is a high performance, self-learning Ethernet bridge. This device is the extension device of Ethernet, using network (PDH/SDH/Microwave) that provide E1 channel to achieve local and remote Ethernet interconnecting with serial interfaces at a lower cost. The device has inter-set loop test function to facilitate the project launching and daily maintenance.

Photos Product Photo

Mini type DC power

Mini Type AC power                         19inch 1U dual power

Features

• Based on self -copyright  IC 
• Support unframed mode (2048K) set and can manage the remote device condition , 

      OAM management data did not take up user’s timeslot

• Have the function of E1 interface loop back check, avoid the converter crashed because of interface loop back;
• Have indicator when the device is power-off or E1 line is broken or lose signal;
• Can set the E1 line that not to send the LINK signal to Ethernet interface while E1 line is broken;
• The Ethernet interface supports jumbo frames (2036 Bytes);
• Inter-set dynamic Ethernet MAC address (4,096) with local data frame filtering 
• Ethernet interface supports10M/100M, half/full duplex auto- Negotiation and AUTO-MDIX (crossed line and straightly connected line self-adaptable );
• Have Ethernet monitor self-reset function, the equipment will not dead
• Can achieve the remote device setting any 5 mode of Ethernet and can closed the AUTO-MDIX function; 
• Provide 2 clock types: E1 master clock and E1 line clock;
• The local device can forced the remote device rate follow it(when the device is unframed mode, that is invalid);
• Have three Loop Back Mode: E1 interface Loop Back (ANA)、Ethernet interface Loop Back(DIG)、Command the remote,Ethernet interface Loop Back(REM)
• Provide 2 impedances: 75 Ohm unbalance and 120 Ohm balance;
• Support SNMP Network Management;
• Can realize monitor of remote equipment temperature and voltage from local equipment; 
• Can form the structure: Ethernet E1 Bridge(A)－－-E1 Optical Fiber Modem(B)－－-Ethernet Optical Fiber Modem (C) 
• Can form the structure: Ethernet E1 Bridge(A)－－-Optical Ethernet Modem(B)－－-Ethernet Optical Fiber Transceiver (C),can manage (B) and (C) at (A)

Parameters

♦ E1 Interface

Interface Standard: comply with protocol G.703;
Interface Rate: n*64Kbps±50ppm;
Interface Code: HDB3;

E1 Impedance: 75Ω (unbalance), 120Ω (balance);

Jitter tolerance: In accord with protocol G.742 and G.823

Allowed Attenuation: 0~6dBm

♦ Ethernet interface(10/100M)

Interface rate: 10/100 Mbps, half/full duplex auto-negotiation

Interface Standard:     Compatible with IEEE 802.3, IEEE 802.1Q (VLAN)

MAC Address Capability: 4096

Connector:     RJ45, support Auto-MDIX

♦ Working environment

Working temperature:    -10°C ~ 50°C

Working Humidity:    5%~95 % (no condensation)

Storage temperature: -40°C ~ 80°C

Storage Humidity: 5%~95 % (no condensation)

Specifications

Application

Applications 1

Applications 2

 Applications 3