OEM/ODM Factory Rs232 Rs485 Converter - Framed E1-FE+4RS232 interface Converter JHA-CE1F1R4 – JHA
OEM/ODM Factory Rs232 Rs485 Converter - Framed E1-FE+4RS232 interface Converter JHA-CE1F1R4 – JHA Detail:
Overview
This protocol converter (interface converter) using large scale FPGA design, providing a framing E1 interface and an Ethernet interface and four serial interfaces, it is possible to achieve 10 / 100Base-T Ethernet data over E1 channels transmission, is a high performance, self-learning Ethernet bridge. The device serves as an extension of Ethernet devices, use of existing networks (PDH / SDH / microwave, etc.) provided by the E1 channels to interconnect both ends of the lower cost Ethernet and serial interfaces. Built-loop test equipment capabilities to facilitate the opening and routine maintenance works.
Product Photo
Mini type
19inch 1U type
Features
- Based on self -copyright IC
- Can realize monitor and control of remote equipment, OAM management data did not take up user’s timeslot and save E1 bandwidth
- E1 supports any timeslot set, the rate is 64K-2048K
- The local device can forced the remote device rate follow it
- Have indicator when the remote device is power-off or E1 line is broken or lose signal;
- Have the function of E1 interface loop back check, avoid the converter crashed because of interface loop return;
- The Ethernet interface supports jumbo frames (2036 Bytes);
- Inter-set dynamic Ethernet MAC address (4,096) with local data frame filtering function
- Ethernet interface supports 10M/100M, half/full duplex auto- Negotination, support VLAN
- Ethernet interface supports AUTO-MDIX (crossed line and straightly connected line self-adaptable );
- Have Ethernet monitor self-reset function, the equipment will not dead
- Provide 2 clock types: E1 master clock and E1 line clock;
- Provide 2 impedances: 75 Ohm unbalance and 120 Ohm balance;
- Support SNMP Network Management
- Serial Data Interface can be RS232/RS422/RS485/TTL optional
- Serial channel can transmit adaptable serial data asynchronously 300 Kbps-19200Kbps baud rate
- Serial data multiplexing in E1 support ITU-T R.111 jumping coding mode
- The local RS232 serial data can command the remote RS232 serial data loop-back to the local. This loop- back in the outer ring of RS232 data interface, you can test the RS232 interface chip without damage
- Serial port interface lightning-protection reached IEC61000-4-5 (8/20μS) DM(Differential Mode): 6KV, Impedance (2 Ohm),CM(Common Mode): 6KV, Impedance (2 Ohm) standard
Parameters
♦ E1 Interface
Interface Standard: comply with protocol G.703;
Interface Rate: n*64Kbps±50ppm;
Interface Code: HDB3;
E1 Impedance: 75Ω (unbalance), 120Ω (balance);
Jitter tolerance: In accord with protocol G.742 and G.823
Allowed Attenuation: 0~6dBm
♦ Ethernet interface(10/100M)
Interface rate: 10/100 Mbps, half/full duplex auto-negotiation
Interface Standard: Compatible with IEEE 802.3, IEEE 802.1Q (VLAN)
MAC Address Capability: 4096
Connector: RJ45, support Auto-MDIX
♦ Serial Interface
Standard
EIA/TIA-232 RS-232 (ITU-T V.28)
EIA/TIA-422 RS-422 (ITU-T V.11)
EIA/TIA-485 RS-485 (ISO/IEC8284)
Serial Interface
RS-422: TXD+, TXD-, RXD+, RXD-, Signal Ground
RS-485 4 wires: TXD+, TXD-, RXD+, RXD-, Signal Ground
RS-485 2 wires: Data+(Correspond TX+), Data-(Correspond TX-), Signal Ground
RS-232: RXD, TXD, Signal Ground
♦ Working environment
Working temperature: -10°C ~ 50°C
Working Humidity: 5%~95 % (no condensation)
Storage temperature: -40°C ~ 80°C
Storage Humidity: 5%~95 % (no condensation)
Specifications
Model | Model Number: JHA-CE1F1R4 |
Functional Description | 1channel framed E1 -FE +4RS232/422/485 converter,With E1 loopback detection function |
Port Description | One E1 interfaces, four data interfaces (RS232) |
Power | Power supply: AC180V ~ 260V;DC –48V;DC +24VPower consumption: ≤10W |
Dimension | Product Size: Mini type 216X140X31mm (WXDXH),1.3KG/piece 19inch 1U type 483X138X44mm (WXDXH),2.0KG/piece |
Application
Typical solution 1
Typical solution 2
Product detail pictures:
Related Product Guide:
So that you can fulfill client's demands, all of our operations are strictly performed in line with our motto High Excellent, Competitive Price, Fast Service for OEM/ODM Factory Rs232 Rs485 Converter - Framed E1-FE+4RS232 interface Converter JHA-CE1F1R4 – JHA , The product will supply to all over the world, such as: Uzbekistan, Rwanda, Dominica, Faced with the vitality of the global wave of economic integration, we've been confident with our high-quality items and sincerely service to all our customers and wish we can cooperate with you to create a brilliant future.
By Arthur from Hamburg - 2017.09.30 16:36
The company's products can meet our diverse needs, and the price is cheap, important is that the quality is also very nice.
By Ricardo from Johor - 2018.06.18 19:26